Phone: 440-543-8271

Email: sales@hitemp.com

25
Jan

Why should I use a circulation pump? Updated 25-Jan-2016

Updated 25-Jan-2016 Early Reverb Furnace Designs The reverberator (reverb) furnace has been in use since medieval times. This diagram shows a primitive reverberatory furnace of an early design. The entire furnace could be constructed from natural refractory materials such as clay. This design has a range of limitations that has led to the modern reverb furnace. For …

7
Jan

Dross Pumping Best Practices – Updated 6 Jan 2016

Update: 6 January 2016: Using a dross pump is not the same as using a vacuum cleaner, although there are some interesting comparisons (which I will leave up the reader’s imagination.). In this post, I will discuss some best practices for zinc dross pumping. Why pump dross? It’s all about zinc pot down time. Dross …

11
Jun

New Poseidon Series Molten Metal Circulation Pump Brings Radical Dross Reduction

FOR IMMEDIATE RELEASE New Poseidon Series Molten Metal Circulation Pump Brings Radical Dross Reduction Chagrin Falls, Ohio – May 22, 2014 – High Temperature Systems, Inc., a world leader in non-ferrous molten metal circulation and transfer technology, announces the introduction of the Poseidon Series molten metal circulation pump. The Poseidon Series pump design is essential …

24
Mar

Reduce Melt Loss AND Reduce Your Carbon FootPrint!

Surface dross generation rates are affected by several factors including: Metal Temperature – Often “dominates the equation” above 730°C (1350°F). Surface Area – Can be moderated by a heavy argon cover gas. Turbulence – Induced by flow and mechanical systems, increases effective surface area. Direct Incorporation – Mechanisms that force gas and dross below the metal …